Görüntüleme (gezinme ile): 3 -- Görüntüleme (arama ile): 1 -- IP: 52.14.168.56 -- Ziyaretçi Sayısı:

Özgün Başlık
Atık Palmiye ve Kanola Yağı Metil Esterlerinin Kullanıldığı Direkt Püskürtmeli Bir Dizel Motorda Performans ve Yanma

Yazarlar
Ahmet Necati Özsezen, Mustafa Çanakcı

Dergi Adı
Gazi Üniversitesi Mühendislik-Mimarlık Fakültesi Dergisi

Cilt
Haziran 2009, Cilt 24, Sayı 2, ss. 275-284

Anahtar Kelimeler
Atık Palmiye Yağı ; Kanola Yağı ; Metil Ester ; Dizel Motor ; Performans ; Yanma ; Püskürtme

Özet
Bu çalışmada, atık palmiye metil esteri (APYME) ve kanola yağı metil esterinin (KYME) performans, yanma ve püskürtme karakteristikleri petrol kökenli dizel yakıtı (PKDY) referans alınarak incelenmiştir. Performans, yanma ve püskürtme karakteristiklerini belirlemek için, 6 silindirli, doğal emişli ve direkt püskürtmeli bir dizel motorda, 1000, 1500, 2000 d / d sabit motor hızlarında tam yük testleri gerçekleştirilmiştir. Test motorunda, APYME ve KYME kullanımı ile PKDY'a göre motor gücünde ve ısıl verimde ortalama %2 oranında azalma meydana gelirken, özgül yakıt tüketiminde (ÖYT) ortalama %6 oranında artış olmuştur. Metil esterlerin ve PKDY'nin silindir gaz basıncı, ısı dağılımı ve yakıt hattı basınç grafikleri incelendiğinde, motorda meydana gelen mekanik yüklemeler açısından, yakıtların yanma grafiklerinin birbirlerine benzer olduğu görülmüştür. Bununla beraber, metil ester kullanımı ile PKDY'a göre ön yanma safhasının daha erken başladığı, tutuşma gecikmesinin daha kısaldığı ve maksimum silindir gaz basıncı bölgesinin üst ölü noktaya (ÜÖN) biraz daha yaklaştığı belirlenmiştir. Ayrıca metil esterlerin kullanımı ile PKDY'a göre yakıt sevk başlangıcının daha erken başladığı da tespit edilmiştir. Metil esterlerin kullanımı ile değişen püskürtme ve yanma karakterleri ve metil esterin yakıt özellikleri, hidrokarbon (HC), karbon monoksit (CO) ve duman koyuluğu emisyonlarında azalma meydana getirirken, NOx emisyonlarında ise kısmen artışa neden olmuştur.

Başlık (Yabancı Dil)
Performance and Combustion in a Direct Injection Diesel Engine Fuelled With Waste Palm and Canola Oil Methyl Esters

Anahtar Kelimeler (Yabancı Dil)
Waste Palm Oil ; Canola Oil ; Methyl Ester ; Diesel Engine ; Performance ; Combustion ; Injection

Özet (Yabancı Dil)
In this study, the performance, combustion and injection characteristics of waste (frying) palm oil (WPOME) and canola oil (COME) methyl esters have been investigated, and compared to petroleum based diesel fuel (PBDF) as reference fuel. In order to determine the performance, combustion and injection characteristics, the experiments were carried out in a six-cylinder, naturally aspirated, direct injection diesel engine at 1000, 1500, 2000 rpm constant engine speeds under the full load condition. When the test engine was fueled with WPOME and COME, while the brake power and thermal efficiency reduced by 2%, the brake specific fuel consumption increased by 6% on average. When the cylinder gas pressure, heat release and fuel line pressure graphics of the methyl esters and PBDF are investigated, it will be seen that the combustion graphics of the fuels seem similar to each other with respect to mechanical loading. However, by using methyl ester, very little combustion differences took place such as earlier premixed combustion phase, shorter ignition delay and maximum cylinder gas pressure region closed to top dead center (TDC) compared to PBDF. In addition, when the test engine was fueled with methyl esters, the start of injection timing took place earlier than that of PBDF. The with usage of the methyl esters changes in the injection and combustion characteristics, and fuel properties of the methyl ester caused reductions in carbon monoxide (CO), unburned hydrocarbon (HC) emissions and smoke opacity, but they caused to increases in nitrogen oxides (NOx) emissions.